On Cable HireTAG
HireTAGs are available in six sizes suitable for use on cables. These are suitable for a range of cables between 6mm (approx 1/6") and 25mm (approx 1") outside diameter.
On Cable HireTAGs can be read from coiled cables
These'on cable' HireTAGs have been specifically designed to cope with adjacent turns on coils of wire and to offer a very large acceptance angle in comparison with standard tag designs all of which means that the cable HireTAGs can be read in a flightcase of coiled cables.
The HireTAGs have rounded ends ensuring that the cable does not snag when pulled along an uneven surface.
Ready Programmed HireTAGs
As with all HireTAGs, they are supplied pre-printed and ready programmed.
HireTAGs are fully protected
The flexible inner is designed to fit a specific range of cable sizes. It holds the RFID chip and antenna and the barcode label and is split to allow it to be fitted over a cable without removing either of the cable ends.
Surrounding the inner is a two part, transparent, protective rigid cover that protects the inner and its contents.
